How do I identify a 46re transmission?
AUTOMATIC TRANSMISSIONS The identification plate is attached to the right side of the transmission case. The 42RE/44RE/46RE is a 4-speed fully automatic transmission with electronic governor. The ID numbers are stamped on the case’s left side just above the oil pan.
Are all 46re transmissions the same?
All 46Re’s are not the same. Basically, the short form is that ’96-99 Dakota and Durango interchange.
What vehicles have the 42re transmission?
- 1989-2003 Dodge Dakota.
- 1998-2000 Dodge Durango.
- 1989-2001 Dodge Ram pickup 150 / 1500.
- 1989-2003 Dodge Ram Van B150 / B250.
- 1993-2004 Jeep Grand Cherokee.
- 1996-1998 Jeep Grand Cherokee 5.2 V8.
How many gears does a 46re have?
Control of the 46RE
They use a sun gear and two planetary gear sets. They had three forward gears and reverse, with the driver controlling the gear by pressing buttons built into the dashboard rather than the more customary gear shift lever. You could find these gear buttons at the far left of the dash.
How can you tell if a transmission is 42re?
How to Identify a Jeep 42RE Transmission
- Go under the vehicle to access the transmission, if still installed. …
- Count the number of bolts attaching the pan to the transmission’s underside. …
- Locate the electronic governor solenoid attached to the transmission housing. …
- Look for the transmission part/identification number and date code.
What’s the difference between 46re and 47re?
Case is a liitle different, 47 uses a larger torque converter, 46 OD clutch as 4 discs 47 has 5, 46 direct clutch uses 8 discs, 47 has 10 disc, 46 has 3 discs in the front clutch, the 47 uses 4. There are other differences too, but they are teh big ones.
Can I tell what transmission I have by the Vin?
Some OEMs also use this section of the VIN to capture transmission information. … Some OEMs still use the same 10-digit VIN patterns for automatic and manual transmission vehicles, meaning that VIN alone will not be enough to determine the vehicle’s transmission type.
Where is the transmission model number located?
Open the driver’s side door and find the white card on the side of the door that is filled with small black lettering. This card contains specific details about the year the car was made, its transmission, engine specifications and other details. Underneath or beside the “TR” symbol will be a number code.
Are 5.2 and 5.9 transmission the same?
There not interchangeable. Other then that,it’s the same. Ask for the build sheet for the 5.2 and the 5.9 then you’ll know the difference.
What is the difference between a 42re and an 44re transmission?
The difference is how much torque they can handle. The 44 is a bit stronger than the 42. They have the same gear ratios. The 46 RE has a larger housing and a different 1st and 2nd gear.
How do I know if I have a 42rle transmission?
The transmission can be identified from the outside by an additional electrical connector sticking out of the case, next to the range sensor connector. It will either be 6 pins or 5 pins. Early connectors had 6 pins, with the #1 pin not being used.
Is the 42re a good transmission?
Personally I believe the 42re is a reliable transmission. It doesn’t really seem to have any common issues, maybe bad solenoids. Mine has 231,000, seems fine. Use the correct fluid, keep them cool, use O/D off when towing anything.
What does 46re mean?
electronic controlled governor pressure
What years did dodge use the 46re transmission?
The 46RE transmissions were first used on 1996 models and these units had computer-controlled shifting, whereas the first generation 46RH transmissions were hydraulically activated similar to the A-727. First gear on the A-518 is 2:45 to 1, with reverse gear rated at 2:21 to 1.
What year did Dodge have transmission problems?
Dodge trucks manufactured between 1999 and 2003 are especially prone to transmission problems. These trucks used the Dodge 45RFE automatic transmission, which had significant reliability issues.