What is a transmission shift cable fracture?

These vehicles have a condition in which the transmission shift cable may fracture at any time. When the fracture occurs, the driver may not be able to select a different gear, remove the key from the ignition or place the transmission in park.

What is a transmission shift cable?

The shift selector cable puts the transmission into the proper gear, which is indicated by the shift selector that it has been moved by the driver. Automatic transmission vehicles normally have one cable that runs from the transmission to the shifter assembly, while manual transmission vehicles have two.

How much does it cost to replace a gear shift cable?

Automatic Trans Shift Cable Replacement Cost – RepairPal Estimate. The average cost for automatic trans shift cable replacement is between $255 and $292. Labor costs are estimated between $140 and $176 while parts are priced at $116.

What causes a gear shift cable to break?

Why Cables Fail

The most common reason for failure of a shift cable is stretching. … Cables have also been known to break, or under some circumstances bend, preventing them from moving the shift lever on the transmission into the correct position for the selected gear.

IT IS INTERESTING:  Question: How long can you run boat motor without water?

Where is the transmission shift cable?

The shift selector cable connects the gear shifter, located on the steering column or on a floor mounted console, to the automatic transmission. The cable is typically steel and is protected from the elements by a plastic outer sheath.

What are the signs that your transmission is going out?

10 Symptoms of a Bad Transmission

  • Lack of Response. Hesitation, or outright refusal, to shift into the proper gear is a telltale sign of transmission trouble. …
  • Odd Sounds. …
  • Leaking Fluid. …
  • Grinding, Jerking, or Shaking. …
  • Burning Smell. …
  • Won’t Go into Gear. …
  • Service Engine Soon. …
  • Noisy Transmission in Neutral.

What happens when shifter cable breaks?

If either cable is broken, the shifter handle won’t return to the neutral position automatically if it isn’t in gear. If the horizontal cable is broken, you won’t be able to shift into any gear.

How long does it take to replace a gear shift cable?

Without a means to shift between gears and neutral, or to shift between park and drive, for example, it’s very difficult to operate a vehicle safely. 2) How long does it take to replace a shifter cable? Every vehicle is different, of course, but an average time to replace a shift cable is about an hour and a half.

When should shifter cables be replaced?

It really depends on the amount of use. Every 2 years sounds good. My rear usually fails in that amount of time. If you are looking for durability, sealed cables are known to last a long time.

IT IS INTERESTING:  Can water make your check engine light come on?

How does a shift cable work?

The shift cable runs up through the firewall and attaches to this lever. The cable runs from the firewall to the transmission gear shift linkage, where it is attached and held securely in place. As the handle is moved, it either pulls or pushes on the cable. In turn, the cable does the same to the transmission linkage.

How do I adjust my automatic transmission cable?

Pull the shift cable back two steps so that the shift position is in N.

Secure the shift cable end with the nut (A).

  1. Remove the 6.0 mm (0.24 in) pin (B) that was installed to hold the shift lever.
  2. Turn the ignition switch to ON (II). …
  3. Shift to P, and check that the shift lock works properly. …
  4. Reinstall the center console.

How do you remove a shift cable from a transmission?

Use a flathead screwdriver and pry the end of the shift cable off of the ring selector stud on the side of the transmission. Move to the middle of the cable and take it off the bracket. The cable is secured to the bracket with a staple-shaped clamp. Pry the clamp out with the flathead screwdriver.

Car service