Quick Answer: What is the correct way to change a car battery?

Which battery terminal do you take off first?

Always work on the negative terminal before the positive when you disconnect your battery. Grab a socket from your socket kit and hold it near, but not against, the nut on the negative terminal of your battery.

Can I change my car battery myself?

Remove the battery hold-downs, bars, or fasteners with a socket and ratchet or a wrench. … Insert the new battery in the hold-down tray, and secure the battery with its appropriate fasteners. Replace and tighten the clamps on their posts—connect the positive (red) cable first, then the negative (black) one.

When changing a car battery which cable do you connect first?

Connect the positive end first. Attach the red/positive (+) cable to the red/positive (+) battery post and tighten with a wrench. Do the same on the black/negative (-) side. Ensure that the connections on both ends are secure by trying to move the battery around.

IT IS INTERESTING:  Can you drive a car with a bad AC compressor?

Do you hook up negative or positive first?

When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.” When you are replacing your car battery, It isn’t always easy to remember the order in which to disconnect and reconnect the terminals.

What happens if you connect the negative terminal first?

If you first connect the negative cable, then when you connect the positive cable there is a chance the wrench will complete a circuit between the battery and the chassis of the car. … If the battery is offgassing, the spark could ignite those gases causing an explosion.

What happens when you put a new battery in your car?

Unless there is a problem with the battery…they are good to go when purchased. Install it, and don’t lose any sleep over it. The next time you drive it, the car will start. It will recharge the the amount used to start it that first time, and bring it up to a full charge at that time.

Why do you connect the positive terminal first?

However for safety reasons it does matter. The whole body of the car is usually connected to the minus pole. And you can accidentally hit that body with the positive lead. So connecting the lead first is safer.

Why shouldn’t you connect the negative terminal?

Caution: Don’t attach the negative cable to the negative terminal of the weak battery when jumping a car battery! This common mistake could ignite hydrogen gas directly over the battery. Battery explosions can cause serious injury. … Finally, remove the positive cable from the car with the weak battery.

IT IS INTERESTING:  Can you change transmission fluid after 200000 miles?

How do I know when my car battery needs replacing?

7 signs your car battery is dying

  1. A slow starting engine. Over time, the components inside your battery will wear out and become less effective. …
  2. Dim lights and electrical issues. …
  3. The check engine light is on. …
  4. A bad smell. …
  5. Corroded connectors. …
  6. A misshapen battery case. …
  7. An old battery.

26 сент. 2018 г.

How often should I change my car battery?

Batteries can become worn down in as little as three years

Just like your computer or smartphone’s battery becomes less efficient with every charge, your car’s battery gradually deteriorates every time it’s charged up by the vehicle’s engine. After three years, it’s normally time to install a replacement.

Is changing a car battery difficult?

Fortunately, replacing a car battery isn’t that difficult and as long as you didn’t get stranded somewhere, the hardest part about this DIY skill is lifting out the old battery and putting in the new one. … Once you’re ready to install the new car battery, shut off the car’s engine, pop the hood, and locate your battery.

Can you touch positive terminal of car battery?

It’s okay to touch both terminals of a car battery with your hands. The resistance in your body is so great that you barely complete a circuit, so you won’t feel a thing. … So just be real careful about what your wrench touches when removing the positive battery terminal. If you don’t touch metal, you’ll be fine.

What happens when car battery cables are wrongly connected?

When the jumper cables are incorrectly connected, the polarity of the electrical system on the vehicle with the dead battery will be reversed for a few seconds. This can irreparably damage many of the sensitive electronic components that are common on today’s vehicles, such as on-board computers and electronic sensors.

IT IS INTERESTING:  Is it worth it to get an electric car?

Why does my car battery spark when I connect it?

The battery cables can spark if the cables are installed in the improper order. When attaching the battery cables, place the positive cable on first and then the ground cable. … Also, the ground, or negative cable, should not be touching anything metal while the positive cable is hooked up.

Car service